October 12, 2018
October 11, 2018
August 20, 2018
August 20, 2018
August 17, 2018
Recognizing Salvage RV Finding a salvage RV can be a great deal. With repairs, the vehicle can be made recreation ready again after a little bit of work. Some salvage RVs can end up being more trouble than they are worth. Recognizing how extensive and expensive it will be to get a salvage RV back into shape will determine whether the salvage RV project is worth taking on.
One of the most absolute devastating types of damage a Salvage RV can incur is water damage. Water tends to infiltrate once it finds an opening and it will spread throughout the camper, inviting the growth of toxic black mold.
Water damage tends to spread outward from the source of a leak, and it can also find a fast track to spread when a leak reaches your ceiling, floors or a corner. If you notice that the roof is sagging or that the floor or walls feel spongy, this means that the water damage has persisted for a long time.
You can also inspect any areas that should be sealed off with caulk. If you notice that the caulk is severely cracked or is peeling, then the seal on that area has failed and water may have already found its way in.
Answering this question depends on the amount of time and money you are willing to spend on a repair project. As a rule, replacing entire floors or walls is undesirable compared to fixing isolated areas.
The best way to determine whether a water damage repair is worth it is to try and determine the source of damage. If the water came from an easily-identifiable source, there are going to be less surprises as you go about repairs.
For instance, a faulty drain line can cause a lot of damage to floors and behind-appliance compartments. However, if you can repair the source and the water has not spread too far, then that is a relatively easy project.
The same applies if you find that only one component was leaking, such as the seal around a window. If an entire roof or wall has not gone soft and rotted out, then the project can be more manageable. If you discover that support beams have become rotten and moldy and it has affected non-organic components like the Styrofoam under the floors, then you can anticipate a much more labor-intensive repair process.
Remember that before the salvage RV project is done, every single mold-infested component must be cleaned or removed, and all seals have to be replaced for waterproofing. This process will be covered more in-depth in part two of this post.